Subject: Sachs air-cooled rotary snowmobile engine specs.
From: ACRE
Date: 5/27/2003, 3:51 AM


Brett & Tiana Campbell wrote:

Hi all,
I recently picked up a Sachs air-cooled (single-rotor) snowmobile engine
originally from an
early-'70's Arctic Cat snowmobile. The price was right, and curiosity got
the better of me.
Interesting contraption--- no inter-housing seals because it's air-cooled,
and the internal
components (ie: rotor and thrust bearings) are lubed and cooled by the
40:1 pre-mix air/fuel
mixture, which is routed through the center of the engine prior to
entering the intake port. I
believe this method is referred to as "charge-cooled and lubricated," but
correct me if I'm wrong.
The basic engine core sans external components weighs approximately 35
lbs, and measures about 13
inches in diameter x about 6 inches thick, with a 12-inch long e-shaft.
BTW, most of the diameter
is cooling fins--- the rotor chamber oval is only about 7 inches x 5
inches, with a rotor width of
just under 3 inches. Only one spark plug is used, and the rotor uses no
oil-control o-rings, only
conventional side, corner, and (single-piece) apex seals. Both end
housings and the rotor housing
are aluminum (even the wear surface of the rotor housing is aluminum, not
plated), with an iron
rotor and solid-steel e-shaft. All bearings are non-tapered roller type,
including those inside
the rotor where it rides on the e-shaft eccentric. I'm not sure if the
apex seals are carbon
steel, cast iron, or some other steel material. Beyond that I don't have
any other specs on this
engine.
Do any of you know what the displacement, rated horsepower, and torque of
this engine is? Also
does anybody have an idea as to the proper running clearances and wear
tolerances of this engine?
Just wondering, because I'm thinking it just might be suitable as a
powerplant for a basic
ultralight, if and when I ever decide to build or purchase one.

Vaughn Mann wrote:

Brett,
Interesting engine you have there.  If no one knows anything about this
engine, I did find a book here
http://www.motorcyclebooks.com/smalairen19a.html that list the specs for the
Sachs and others that may help.
Keep us informed if you find out about it.  Thanks, Vaughn.

I was at the Wankel factory in 1999 and they had a Sachs powered motor cycle in
their lobby. It was also used in some small racers that you paid to drive 
around a short race track.I think it was called Grand Prix
America or some such.


Paul Lamar


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.