Subject: The ultimate NA aircraft rotary engine intake manifold?
From: ACRE
Date: 5/27/2003, 3:41 AM


In the 3D rendering shown here the outer movable portion of the
manifold is actually separated from the annular hydraulic cylinder portion
for illustration purposes only. The actual manifold will only
extend out from the engine eight or ten inches. The total loop length
should be 17 inches at 6000 and less at higher RPMs. A half inch change
in annular piston position will change the loop length by one
inch.

Paul, with a tuned intake don't you believe you will get max power with two straight intakes? I
like the simplicity of the intake, but is the dynamic chamber truly effective in the range of rpm
needed? Doesn't this design require hot side fuel? Just wondering. Bill Jepson

Excellent questions. I am very happy you asked that as there are
some people out there, quite a few in fact, that are attempting
to adapt the existing Mazda dynamic chamber design to their aircraft
engines running at 5500 RPM and above despite my contentions it is
unsuitable for use in aircraft engines. IMHO it is designed to work
at around 3000 RPM.

The question remains however whether the dynamic chamber SPECIFICALLY 
DESIGNED for 6000 RPM really works better or perhaps worse than
the conventional tuned straight, or moderately curved runners
for that matter, feeding off a conventional large volume plenum.

The jury is still out.

Yes it does required hot side fuel. I forgot about that.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.