-- Brett & Tiana Campbell wrote:
Vaughn, Thanks for the info. The site was very helpful, and based on your
info regarding carbs this engine is a Sachs KM914B of 303 c.c. displacement
since it uses a Tillotson HL side-draft rather than the Mikuni used on the
later-model 295 engine. It looks very much like the engine on the race car
photo posted by Paul--- same fan and recoil starter, with gobs of cooling
fins. BHP was quoted as 19 at 5500 rpm, with 20.3 lb-ft of torque at 4000
rpm. Previous owner said that the Arctic cat that it was in was one of the
faster sleds around at the time once rpms built up, but bogged down badly at
lower revs due to the weak torque in that range. This testimony comes as no
surprise. As I mentioned earlier, the engine weight sans fan/starter &
magneto assembly, clutch, carb, and muffler is 35 lbs. Completely assembled
weight with all above components (except for the clutch, which wouldn't be
required on an ultralight) is 67 lbs. This means that a belt-driven 2:1
ratio redrive would double the torque to 40.6 lb-ft, and provide a total
(estimated) F/F weight including prop and mount of a little over 100 lbs.
Since my knowledge of ultralights is suspect at best, do these figures sound
realistic for that application? What about using it on a powered parachute
or hang-glider? Again, thank you and everyone else who provided info. This
is interesting stuff! Brett.
Your quite welcome Bret!
I'm not sure on the doubling factor of torque but I am sure it would bring
it up significantly, Paul and the crew can probably help you on that one.
As far as the weight factors, take a look at the Rotax and Kawasaki etc.
utralight engines and compare weight with comparable hp ranges. Most of
these already come with the redrive built in BTW. I would like to know what
you come up with as in the future I'd like to adapt one for the Farm. All
of the ultralight owners/pilots I talk to always mention the tremendous
amount of maintenance they perform on the common Rotax to keep them flying.
I would rather see a Rotary as the power source on mine if I buy/build one
in the future. Vaughn.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.