Would this be a good time to point out that pretty much everybody
flying a rotary now & in the near future is/will be using a fixed pitch
prop?
;-)
Charlie, hope this doesn't amount to piling on when everybody
starts chiming in. You have ignored the electric prop, like the one
Paul, Butch, Perry et al have been working on. MT sells suitable
props now, however overpriced they may be. They work fine
and are even certified. Bill Jepson
********************************************************************************
"NOT IF I CAN HELP IT"!!!!!!!!Charlie.......I'm trying very, very hard and I'll
keep on trying harder to provide an affordable, safe and legitimate 200HP + Hub
that will eventually pay for itself just in Maintenance and Fuel economy
savings alone.....I usually have a pretty good nose for these things, and don't
waste my time on non worthwhile things.
So..."Au'contraire' mon amie"....I prognosticate a lot of LAEV's will be in the
air very, very soon since the majority of the work has been done.
I'll even go one better, I'm going to force these high priced "F--K--S" in the
prop business, to come up with an affordable experimental HP-HP matched
competitor :)
Butch
Hi Bill, Butch,
No, I didn't forget about the LAEV prop; in fact I'll probably be a
customer. My point is that even though c/s props are available for
Lyc's, the vast majority of builders still use wood or the new sensenich
(sp?) f/p metal prop.
Even with a variable pitch prop, where is the need to tune over a broad
rpm range? If you tune for cruise rpm & can make, say, 160 hp at
cruise, then you will probably make 190 to 200 on takeoff. Is it really
worth the complexity (in the airplane) of variable length intake ports
to get another 5-10 hp which will be used only on takeoff?
I see a lot of value in using it on a test stand, along with variable
length exhausts to determine the most efficient combination for cruise
in a plane.
Perhaps Lynn can weigh in on this; I suspect that all this intake
tuning stuff will change completely when the exhaust is changed.
Hmmm...Maybe that's the best argument for making it adjustable.....
CE
I would not say it would change completely. Exhaust tuning definitely has
an effect. Particularly something like an engine with both
peripheral intake and exhaust ports.
The shape or broadness of the torque curve varies with the type
of tuned intake system one uses. If you look at these
Lemans engine torque curves you will notice that the
same length simple tuned pipes have a very narrow bandwidth.
The torque drops off about 16% +/- 500 RPM.
At +/- 1000 RPM it is really in the basement.
That is not the HP curve of course but it will have a large
effect on the HP. I think one would pay a large HP penalty at
6500 RPM with a simple same length tuned pipe system tuned for
cruise say at 4500 RPM cruise.
The dynamic chamber on the other hand has a much wider
bandwidth at its two tuned RPM points.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.