Subject: Mark Wrathall/fuel injector sockets
From: ACRE
Date: 5/30/2003, 10:13 AM


These can be made for peanuts if using conventional injectors.
I made 16 for a friend doing experimental work on an engine.
Took about an hour to make them all on a manual lathe..
Only need a lathe and a special injector core drill from MSD (approx $100.)
If setup on a bar feed CNC, could make about two a
minute.


Mark Wrathall made a few for me- he might be interested in making a few more. He's looking at saving up for an RV-4, so any money he would be making from them would be going toward a good cause. Not sure if he has the time to make them. Mark?
Brian Trubee

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.