Subject: Aluminum end housings status.
From: ACRE
Date: 5/2/2003, 4:01 PM


Paul wrote:
Just came away from a meeting with the aluminum end housing coalition.
IE. Foundry.. machine shop.. pattern maker.
They have come up with a very VERY good way of positively locking the through
hardened steel wear surfaces into the aluminum castings. We are
all very excited about the prospect of a 150 pound rotary engine
putting out 250 HP and doing it with no fuel burn penalty.
Now if I can get 15 pounds out of a 3:1 gear box we
will have one heck of an aircraft engine.

Fred Osborn wrote:

This sounds more and more like "a coalition of the willing".
Bless you Paul. Would you at least begin to accept
non-refundable deposits as a form of contribution ?

Fred O.

I'll check with the coalition. They are talking about buying a
new NC mill. How much did you have in mind?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.