Subject: Aluminum end housings status.
From: ACRE
Date: 5/2/2003, 4:04 PM


Just came away from a meeting with the aluminum end housing coalition.
IE. Foundry.. machine shop.. pattern maker.
They have come up with a very VERY good way of positively locking the through
hardened steel wear surfaces into the aluminum castings. We are
all very excited about the prospect of a 150 pound rotary engine
putting out 250 HP and doing it with no fuel burn penalty.
Now if I can get 15 pounds out of a 3:1 gear box we
will have one heck of an aircraft engine.

Paul Lamar


Ya know... a 400 hp three rotor Harmon Rocket or F1 Rocket would kick so
many butts it would be just silly      P-)
MGM

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode

Why stop at 400 HP? A 900 HP three rotor has been done on the dyno. Would work
great in a Nemesis Next for Reno or most other 100 mile cross country air racing. 
I think it would beat most small single engine turbines airplanes in a 1000 to 
1500 mile race simply because it would not have to stop for fuel and it would 
generate way more power up high.

Two out of the four end housings are aluminum in this RB engine pictured below.

There also is that sprint car water pump I mentioned in a few messages back.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.

complete-less-wireing.jpg