Just came away from a meeting with the aluminum end housing coalition.
IE. Foundry.. machine shop.. pattern maker.
They have come up with a very VERY good way of positively locking the
through
hardened steel wear surfaces into the aluminum castings. We are
all very excited about the prospect of a 150 pound rotary engine
putting out 250 HP and doing it with no fuel burn penalty.
Now if I can get 15 pounds out of a 3:1 gear box we
will have one heck of an aircraft engine.
Paul Lamar
Dan Ruggirello wrote:
That's great news Paul! If the price is right, I'll be signing up for these
housings. BTW, are you planning on doing a radiograph or ultrasonic
inspection of the metal to metal joint as part of the development process?
I don't see any reason why at least 15 lbs can't be shaved off a gearbox
with the proper housing design. I'll lend any support I can to get a
lighter weight gearbox going. I am still thinking about making an ultimate
bell housing mold, but if someone can get that going sooner, I'll do any
stress/dynamics required. I think a solid stress and dynamics analysis will
be key to making a lightweight gearbox.
If the 150 lb /250HP goal becomes reality - sooner or later good bye
!
Dan
Me too on the mold. I was thinking a spinning on the bell housing part
and welded aluminum tubing on the rest of it along with some machined
aluminum plate (ribs with draft). All tig welded up. I think a
six pinion ring gear held stationary with power out of the planet carrier
on a A4OD 2.17 gear set will yield a 3.15 over all gear reduction
for an RX8 based motor. 8500 takeoff RPM divided by 3.15 is 2700 RPM.
Lycoming should give up now. Resistance is futile.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.