Subject: 12A throttle body size
From: ACRE
Date: 5/15/2003, 2:08 PM

George Lendich wrote:

Paul,
I've worked out the area of the manifold tubes for the 12A and added 20 percent which gave me 2.5"
throttle body - is that about right.

I initially allowed 20 percent for the boundary layer of the tubes, thinking that's more than
enough. However I don't know if I should allow for more for some turbulence in the plenum.
What do you think !?
George (down under)

A 2.5 throttle body will work but you probably would get slightly more
power with a three inch. I don't really have a curve of size
verses pressure drop as a lot depends oh how streamlined the butterfly
mechanism is.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.