Subject: Manifold castings & pipes
From: ACRE
Date: 5/15/2003, 2:02 PM


Hello Paul -- I think I missed some N/L msgs some time or other.  I need an
intake casting from your 3d batch for an 86 NA engine, also the intake pipes.
  Don't have a 2d gen casting to trade in, but would like to get the 3d gen
casting if at all possible.  Don't need the water pump either.  Would
appreciate if you would let me know if these are available and what the cost
will be.   I'll send you a check.
Yours for fun flying -- Buck Buchanan

We will have some 3rd batch manifolds in a few days. They are in the
machine shop.  The 2nd batch of runners will take a bit longer. I was over 
to the foundry yesterday and the foundry man was complaining about my runners 
pattern. I revised it three times already and he wanted me to revise 
it again. So I complied and spent the last 24 hours reworking it 
yet again. When I dropped it off today I told them this joke. Back 
in the days when I was a race car engineer I dealt with picky 
drivers who liked to make a lot of inconsequential chassis
changes during and practice qualifying. I told the offending
race car drivers; "We make only three changes, the front sway bar,
the rear sway bar and the driver."! :)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.