Edward Klepeis wrote:

   Dear Joe
        Some of the sizes I can get are 18x18x2.25 , 12x18x2.25 these can be turned sideways for
cross flow or vert. which every meets your space req. As far as fitting and mounts go I can weld
in straight barbed fittings or  NPT bung pipe fittings which can have 3/4 or 1''  right angle,
45degrees, or straight fitting screwed into it and pointed at any direction to make your set up
simple and most direct.Mounts can be hat section with rubber doughnuts  or  right angle mounts
with doughnuts.If you have any questions please e mail or call me at the  shop.
                                                                                                 Regards
                                                                                               
Ed Klepeis

klepeis@vci.net
                                                                                          
270 898 3776

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.