Subject: Mustang II radiator planing ahead
From: ACRE
Date: 5/26/2003, 6:43 AM


ddunbar wrote:

Hello Paul,
Well back to plan A as all other are out.
Attached is the radiator position which is inside the standard cowl in
some fashion.

--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

Good thing too :) When I did mine which is a lot tighter
than the Mustang I optimized the motor mount and the oil pan
for that position so I could get it up a bit higher. That is
also why I like the psru/motor plate/motor mount as the
main rubber bushings can be well up alongside the engine
maximizing the room under the ring gear for a rad duct.
It was at this early stage of mock up that I realized I had
to get everything out from under the ring gears and the
rear (front in airplane) of the engine as I could.

You lucked out because the Mustang II cowl is so fat :)

For all you new guys. Another example of why it is
EXTREMELY IMPORTANT to plan ahead with 3D software or make
a COMPLETE mockup with all major parts before you buy anything!

Paul Lamar

I want to expand on this thread as it points out one of
the most if not the most critical dimension for almost all rotary engine
installations. That is the vertical distance from the bottom
of the ring gear to the bottom of the cowl. It is critically
important to keep everything out of this area that is humanely
possible. It will require a wedged shaped custom oil pan. 
Notice too how the main motor mounts are moved up and out to give
as much free space in this area as possible.

Here are some more pictures. In this case the rad is
pushed up under the flywheel. After we figured out that this
would not work as it blocked the air coming out of the
back side of the rad we went to placing the rad flat and bringing
the air in over the top. The back of the rad could then
dump the hot air down and out the bottom of the cowl
totally unobstructed. Same difference as the space required 
for the air intake duct is the same.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.