Perry Mick wrote:
OK, after years of fussing with this thing I'm convinced that the oil
cooler to the left of the engine just won't work. I don't have any ideas
where else I could put it, do you?
I bought a differential pressure meter from McMaster Carr, reads out in
0-15 inches of water. I get NEGATIVE 7 inches of water at the inlet, and
negative 3 inches at the exit relative to static. So the air is still
flowing through the oil cooler backwards. This is exactly the same
result I got over a year ago with an airspeed indicator. Apparently
that "ram" air inlet under the strake is no such thing. That must a
terrible place to try to get some high pressure air. Maybe the leading
edge of the strake being swept has something to do with it? I did NOT
have the ports reversed, there is truly negative pressure in the inlet.
I think I'm just going to have to hang that ugly thing out in the breeze
under the belly. It is wider than the fuselage of the Long-EZ!
--
Perry Mick
Custom Composite Props
mick@bridgingworlds.com
http://www.ductedfan.com
Good old Magnahelix.
I don't think it is 7" negative. That would blow me away if it
were really 7" negative. Something REALLY weird going on. It is more
likely 7" positive in front of the intake and 3" positive on
the top of the oil cooler with a net 4" across the cooler.
I am assuming you are using porous kitchen foam on the ends of
the tube as per the pic below.
OK what is the current condition of the exit of the oil
cooler? Is the pressure tap on the back of the cooler right down on the
cooler it self? It is hard to do this by remote control
without a digital camera.
What is a good day for me to fly up to Portland and mess with
this Perry? This coming weekend? I can meet Mike McKee
and we can all drive over together to see Ken's new Coot.
Portland mini rotary get together. I'll bring my water manometer
and my digital camera and we can set the manometer in the
back seat and you can take pictures over your right shoulder of
the manometer. I'll also bring my notebook computer so we
can look at the pictures full size. Think about a bracket
over your right shoulder that will hold the camera with
a 1/4" standard tri pod camera hold down screw which I have.
Or I can Fed X the whole works up there and you can Fed X it back
when done. More fun and quicker for me to come up.
Get some 1/8" plywood door skin and blue foam and we can build a
prototype air exit. Or we can extend the air intake forward
ahead of the the strake. That would be less drag than
mounting the cooler under the fuse.
I am sure I can get this to work.
Paul Lamar
Here are a couple of pictures of what I think Perry has right at the moment.
What is in that bulge at the root of the strake? Could we build
a triangular shaped duct that went all the way forward to the leading edge
of the strake? I don't really think that is necessary but if it is
really 7 inch negative that would be a sledge hammer solution.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.