Are ready to ship. It just takes a few minutes to match
the gasket with a carbide burr and a die grinder
for the 1986-1992 four port shown in the middle.

The third gen (post 93 engines) with the larger ports
will work but it takes a bit longer shown on the
bottom to match the gaskets.

Paul Lamar

Marc Wiese wrote:

Paul,
Assuming the one you sent me is not similar to the third gen one you
show here, can I exchange it for a third gen manifold?
I am still in the process of moving, so it is difficult to get to
everything to check it out.

Marc Wiese

It is the same casting except a 1/4 inch more material was added on
one side. Have your welder weld on a small piece .4 inches thick by 3/8" long
by 1/4" wide when he welds the tubes to the manifold. Not worth shipping 
it back and fourth. When you lay out the 3rd gen holes you will know
where it is needed.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.