Subject: Intake air velocity was manifold weight
From: ACRE
Date: 6/6/2003, 2:13 PM

Chris Cosman wrote:



At what RPM would you be getting supersonic airflows?



Good question. Lets say the displacement is
80 cubic inches  per revolution.
Volumetric efficiency E = 100% Mazda rotaries can do better
than that by a bunch.

Never the less 80 times 6000 RPM is 480,000 cubic inches per
minute. Bear with me as I am thinking out loud.

Lets say the area of all four pipes is 8 square inches
for starters. Each pipe is 2 square inches.

480,000/8 = 60,000 inches per minute.

60,000 /12 = 5000 foot per minute

About 60 MPH Average. Peak speeds could be twice
that or more.

Still sounds low. Check my arithmetic. Perhaps I made a mistake.
Perhaps my approach to the problem is also wrong. I suspect it is.

Taylor says on page 203 Vol. 1 inlets average .5 Mach for high VE
engines.

Another way of calculating it is to use the max speed of the rotor face
moving away from the port adjusted by the port area to rotor face
area ratio. It is really hard for me to figure the max rotor face
velocity
right at the moment :)  There are some charts for this in the book
"Rotary Engine" as I recall.

For a piston engine peak inlet air speed in fps is peak piston speed
in fps times piston diameter squared divided by port diameter squared.

Gas speed = PS X (D^2/d^2)

According to the book "Scientific Design of Intake & Exhaust Systems".
Page 78.

They don't say whether D and d is in feet or inches.
I suspect inches. I guess the ratio would be the same
so it may not matter.

You can figure the peak piston speed by knowing the stroke and RPM.

Peak piston speed inches per minute =  stroke X pi X RPM

Note also this is not the speed of the pressure wave which does indeed
move somewhere around Mach one depending on a couple of factors.

Paul Lamar


I think your approach is correct.

So... to properly tune intakes you'd need to account for the speed of
the pressure wave
minus the speed of the medium it's travelling through, is that correct?

Chris C.
microcosman.com/aircraft

I disagree. I think my original approach was and still is incorrect.
I think the approach they take in the book  Scientific Design of Intake & 
Exhaust Systems IS correct.

Yes on the one hand pressure is increased in one direction and decreased in the
other. It becomes very complicated. I would have to summarize the book Scientific 
Design of Intake & Exhaust Systems or scan in the whole book. 
I suggest everybody just get a copy that is interested in this subject.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.