Subject: Runner area. How the Wankel works.
From: ACRE
Date: 6/6/2003, 3:15 PM


http://www.newcovenant.com/speedcrafter/calculators/intake.htm

Here is an interesting Spreadsheet for calculating Torque peak.

Lynn E. Hanover.

Thats pretty amazing Lynn. Thanks for finding that.

Paul Lamar

It is pretty amazing, because it computes that for my engine my port
(1.75" dia) is optimum for peak torque at 5770 rpm.

Al

Did you use 212 cubic inches and six cylinders Al?
I got 1.71 using those numbers.
Only your big runners are 1.75" from the looks of this pictures.
Your small runners look to be considerable less area.

Paul Lamar

Paul, I think for Al's 3 rotor you would need to use something like 360
cubic inches and 9? cylinders.

Ed Andeson


Not true. Statements like this indicate a lack of fundamental
understanding of how the rotary really works. This is also
why you are confused on the intake manifold.

A three rotor is a three cylinder 2 cycle
or a six cylinder four cycle. Forget the three faces on the rotors.
The ONLY thing that counts is the intake, firing and exhaust events
per revolution of the e-shaft. Think of it as a mysterious black
box with air pulses going in and exhaust gas pulses and HP pulses
coming out.

What is confusing is the fact of the timing of the pulses in the
individual pipes. A three rotor has only three exhaust pipes but
the volume of exhaust gas coming out is the same as the six pipes
of a six cylinder four cycle engine. The number of side port intake
pipes is exactly the same however and so too the total volume of air
going in. It just goes in the pipes at different times.
You need to get some of the early books on the Wankel
such as Yamamoto's Rotary Engine and the Norbye or Ansdale books.

Paul Lamar

The rotor acts like one 2 cycle piston with three separate interchangeable piston tops that
are magically changed out each revolution of the e-shaft. Remember...
the rotor turns at one third of the e-shaft RPM.

Rotor face #1 is used as the piston top for the 1st revolution or cycle of the e-shaft.
Rotor face #2 is used as the piston top for the 2nd revolution or cycle of the e-shaft.
Rotor face #3 is used as the piston top for the 3rd revolution or cycle of the e-shaft.
Rotor face #1 is again used as the piston top for the 4th revolution or cycle of the e-shaft.
Rotor face #2 is again used as the piston top for the 5th revolution or cycle of the e-shaft.
Rotor face #3 is again used as the piston top for the 6th revolution or cycle of the e-shaft.

And so on and so on.

That is all there is to it. It is no more complicated than that.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.