Subject: EGT mystery
From: ACRE
Date: 6/10/2003, 10:14 PM


Al Gietzen wrote:

There is an interesting anomaly in  the EGT data from the dyno run
that
I can't explain; maybe someone has an idea.  For the most part the
EGTs
of the three rotor were relatively close and consistent.  Some
variation
in spread with rpm that I would expect from different air/fuel
flow
characteristics.  The thing I can't figure is this:

Most of the operating was done rich of peak, and at 5000 rpm EGTs
were
within about 50 degree range with rotors 1 (the lowest) and 2 very
close, and 3 the highest.  Maintaining rpm at 5000 by reducing
load as
mixture was leaned (EC2), the EGTs crossed and spread out, so that
by
about 150 lean of peak rotor 3 was the lowest (1510), and rotor 1
was
the highest (1595.  MAP was constant at about 24", rpm constant,
so air
flow didn't change. ).  I assume that the injector pulse width was
reduced by the same amount on all three rotors.  What gives?  It
seems
it might be important to know.  Tracy?

Al


Sounds  exactly likewhat I would expect Al.
At the rich of peak condition, #3 was the leanest of the three and
therefore, the hottest. (injector variation,  pressure distribution,
or
whatever)
At lean of peak,  #3 was still the leanest and therefore the coolest.

At the extream lean condition a very small change in mixture can make
a big
difference in EGT.

I use the differential mixture adjustments on the EC2 (modes 4 & 5) to
equalize EGT at the cruise condition and ignore minor variations at
other
throttle settings.


By George; I think you've GOT it!  (Just don't preface it with 'exactly
that I would expect'; it just makes me fell dumber :).  But thanks.

Al

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.