Charlie & Tupper England wrote:
Hey Tracy,
Speaking of 'feature creep' on your new engine/air data box, how about
this for the reduction drives (updated to use strain guages?).
Charlie
Hi Charlie,
Oh sure, load something else on my plate : )
I already added HP readout to the EM2 (based on fuel flow & BSFC). I know
this is still a theoretical rather than actual HP readout but for our
purposes it is very usable.
And I like the strain gauge idea. Paul's annular piston would work
perfectly but would be impractical to implement. But a strain gauge on the
back of the adapter plate would be very easy and I just might experiment
with that. Only possible glitch is that the hydraulic axial damping system
on the input shaft (using oil pressure) causes an additional thrust on the
sun gear that would have to be factored out of the reading. No big deal if
the function were integrated into the EM2 which has access to oil pressure
info.
But back in the real world, all my 'feature creep' energy on the geardrive
is going into a chip detector system which will be an orderable option when
ready. It is retrofitable to earlier drives too. Between that, the 2.85 :
1 RD-1C and the EM2, I'm tapped out just now. The strain gauge experiment
will have to wait awhile. Any volunteers?
Tracy
Why do you think this is impractical to implement? It is not nice
to make hit and run statements like that :).
This is pretty easy to implement. No need for delicate strain gages and
strain gage amplifiers. (I did not just fall off the electronic instrumentation
turnip truck. :)) I am not asking for any electronic changes. Just a simple
addition to the gear box.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.