Subject: The most amazing thing I have seen so far.
From: ACRE
Date: 6/16/2003, 10:42 PM


Perry had a cooling system malfunction in his 290,000 mile daily beater RX7.
 > A> It is still to be determined what the problem really is
 > A> but one of the things that happened was his water pump failed
 > A> catastrophically.
 >
 > A> A few years ago we had a heated debate
 > A> on this subject. Some felt that cavitation was a big problem
 > A> in Mazda water pumps and that the pump should be slowed
 > A> if you were going to run the engine at super high RPM. Perry's engine
 > A> briefly touched 7500 RPM for some reason not clear to me.
 > A> Perhaps he missed a shift.


The radiator is plugging up a bit. The radiator is the restriction in the
cooling loop. When the engine is revved up, the coolant pressure drops close to
boiling in the area between the radiator and the suction side of the pump. The
lowest pressure is in the center of the impeller. The pump is cavitating a lot
of the time. Not too long after that, there will be no blades on the
impeller. Early in the process it may cause the collapse the lower hose. It is
supposed to have a wire support to prevent collapse.

Later in the process, the flow rate is so low that hose collapse is no longer
a problem.

Not a problem for street cars if the coolant level is maintained, the
pressure cap is a  high enough rating, the radiator is clean, there is a restriction
in the loop that causes more drag than the radiator, Like a thermostat, and
there is a support wire in the lower hose.

All of the coolant in the race engine leaves the engine through a hole just
under 5/8".
Never a cooling problem.

Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.