Paul,
I summarized the results from the photos best I could. Numbers in red are supposedly "bad",
that is, pressure at the exit or suction at the inlet. Numbers in blue are uncertain, best
guess, couldn't read the photo very well or the reference level was below the bottom of the
photo.
E1-E4 is exit, 1 being front and 4 rear. I1-3 is inlet, 1 front 3 rear. dp is delta-pressure.
There is also a column for the average of the dps.
Overall, my impression is the exit duct really increased the suction at the rear, which is
what you would expect. But the suction feeds forward into the inlet. It looks to me like the
best solution would be to retain the exit duct for good suction at the back and increase the
inlet size to get more pressure on the inlet.
Temperatures were about the same or even a little higher after we added the exit duct, but
the engine was already warm from the previous flight. The numbers indicate the pressure drop
across the cooler increased with the exit duct in place.
Also note that none of the dp numbers are red or negative. There is no reverse flow.
That is my take on it.
Perry
OK I guess I was ass backwards on what was reference and what was data. Sorry if I confused
anybody. It just blows me away that the intake duct and scoop need to be yet bigger.
If you are going to keep the exit duct there is no need for the louvers. That might
improve the flow. I also find it hard to believe that with that much implied
air flow it is not cooling any better than it is. Perhaps your cooler is clogged.
Try taking it to a rad shop and have it reverse flushed. The next step
may be to install temp sensors on oil cooler inlet and oil cooler outlet.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.