Paul,
I summarized the results from the photos best I could. Numbers in red are supposedly "bad",
that is, pressure at the exit or suction at the inlet. Numbers in blue are uncertain, best
guess, couldn't read the photo very well or the reference level was below the bottom of the
photo.
E1-E4 is exit, 1 being front and 4 rear. I1-3 is inlet, 1 front 3 rear. dp is delta-pressure.
There is also a column for the average of the dps.
Overall, my impression is the exit duct really increased the suction at the rear, which is
what you would expect. But the suction feeds forward into the inlet. It looks to me like the
best solution would be to retain the exit duct for good suction at the back and increase the
inlet size to get more pressure on the inlet.
Temperatures were about the same or even a little higher after we added the exit duct, but
the engine was already warm from the previous flight. The numbers indicate the pressure drop
across the cooler increased with the exit duct in place.
Also note that none of the dp numbers are red or negative. There is no reverse flow.
That is my take on it.
Perry
OK I guess I was ass backwards on what was reference and what was data. Sorry if I confused
anybody. It just blows me away that the intake duct and scoop need to be yet bigger.
If you are going to keep the exit duct there is no need for the louvers. That might
improve the flow. I also find it hard to believe that with that much implied
air flow it is not cooling any better than it is. Perhaps your cooler is clogged.
Try taking it to a rad shop and have it reverse flushed. The next step
may be to install temp sensors on oil cooler inlet and oil cooler outlet.
Paul Lamar
Paul, didn't you see my oil cooler, it's beautiful! I sent it in to
Pacific Oil Cooler down there in CA a year or two ago, they cleaned it,
straightened the fins, and anodized it. I was hoping it would improve
cooling when I put it in the plane, but there was no difference.
I don't know why my oil temp is higher than everyone elses. I do know it
gets high in the car also, I took some measurements way back. It is
directly related to RPM. Could be that '82 oil cooler I use, maybe there
are some internal differences in the '86, but externally they are the
same dimensions. I would have to have the '86 oil cooler ports plugged
and new ports welded on in different location to use it. I don't want to
go through all that work without knowing for sure there is actually a
difference. Someone said at one time there were "turbulence generators"
inside the tubes of the '86 that might not be in the '82?? Does anyone
know for sure? Maybe I have to ruin a couple oil coolers and cut them
apart to find out?
--
Perry Mick
Custom Composite Props
mick@bridgingworlds.com
http://www.ductedfan.com
I did not look at it very closely or notice any difference. Too focused on other things.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.