Subject: Oil Cooler Test Results
From: ACRE
Date: 6/17/2003, 6:44 PM


Paul,
You made an observational error. The t-fittings for all the reference
tubes are on the right
side. Take another look at the data with that in mind and I think you
will get results
comparable to what I had with the differential pressure meter: about 1"
pressure at the inlet
and 2" suction at the exit in climb, 4" pressure at the inlet and no
suction at the exit in
cruise.  I'll look at the photos you sent later today to see if this
correlates.

Perry


Well perhaps but I don't think so. Picture one and picture three are
definitely reversed.
But yes there is no suction in cruise. Still a slight positive pressure back
there.


Paul Lamar


Here's what I think is going on..

The fan duct is creating a high pressure area in front of it.  This is what
you would need from an energy view if you were accelerating the air through
the duct for the small diameter prop to take advantage of.  The duct in
this case is similar to a venturi, high pressure in front, lowest just a
hair aft of the constriction  and still low out back.  In order for the
cooler exit on top to see low pressure you would need your exit duct to end
in the sweet spot of the venturi.  Unfortunately there is a prop there!

I would bet all the money I don't have that if you took static pressure
measurements in front of the duct you would find a high pressure area at
least within one duct radius of the face of the duct.  With the engine cowl
taking up a lot of the center of the duct the high pressure probably
extends even farther forward.

The exit of the oil cooler duct will need to be outboard of the prop duct
in a lower pressure zone.

To work around this and take advantage of the existing cooler location I
would try:
1)  Leave the top (or bottom) of the cooler open to the sky ala "cowl
induction".  (I don't think I'll have to explain this to Paul).  This will
take advantage of the high pressure area and still give the prop and duct
an unobstructed flow.

2)  Make the new exit duct on the bottom (or top) as thin as allowable and
initially running outboard until it clears the outboard edge of the prop
duct.  Outboard of the prop duct open it to the rear such that it develops
a bit of suction.

Well that turned into an epistle.  You see where I'm going with this
though?  I know from my skydiving days that it was amusing the different
body and arm shapes you could do that would affect your free fall
speed.  Being "bowlegged" with your toes touching and making a hoop with
your arms and touching your fingers will slow you down a few mph.  You can
feel it and see it when everyone else falls away from you (faster).

Mike

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.