Someone said at one time there were "turbulence generators"
inside the tubes of the '86 that might not be in the '82?? Does anyone
know for sure? Maybe I have to ruin a couple oil coolers and cut them
apart to find out?
--
Perry Mick
Perry&Paul, I understand how you want to make this work. My
"best guess" is with Brian with Paul's vortex thrown in. The duct
must function as a restriction in climb with the standoff slowing
exit from the oil cooler. Perry my suggestion to you is to remove
inlet, plug the outlet, and use a oil to water cooler plumbed into the
radiator. There are some good ones and one of the larger units would
fit fine in the current oil cooler location. The bottom inlet of the radiator
is best for high angles of attack anyway. The removal of the inlet scoop
would help increase thrust too. May be a hassle but seems easier
than dealing with the current problem. Bill Jepson
I don't think Perry's water radiator would be up to one third more cooling.
The other good thing about an air/oil cooler is it is a parallel system
and as such it gives a measure of redundancy. Check the ACRE NL
web site on my article on How to Cool a Wankel for more info on
water/oil coolers.
We need to figure this thing out. Perhaps Perry's 82 RX7 oil cooler is too
inefficient. A later version may work better. Seems like it is getting
enough air. I guess Perry is convinced to keep the exit scoop so perhaps
making the intake scoop larger and removing the now redundant venetian blind
type louvers will do the trick.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.