Here is the basic set up.
>From left to right the manometer tubes are Exit 1 though 4 and Intake 1
through 3 starting at the closest to the front of the airplane.
the porous foam pressure taps are more or less equally distributed along
the length of the cooler right down on the core.
This system worked fairly well except for a pusher prop phenomena
which I will describe later.
Paul Lamar
The manometer picture is 80 Kts (92 MPH) on climb out.
The cockpit reference pressure is the left set of tubes.
Exit tap E1 is showing +1" E2 is +2" E3 is +3" and E4 is +3.5" ??????
Intake taps are I1 is -.5" I2 is -.5" and I3 is -.25 ??????
Dynamic pressure at this speed is 4 inches of water so the intake
is showing negative pressures instead of positive pressures!!!!!!
A normal intake, and this is indeed a normal intake, should show
about 50% to 80% of dynamic pressure or around 2 to 3 inches POSITIVE!!!!
What the heck is going on????? My theory is the prop is
dragging air around in front of it in a vortex. This vortex has a
vertical component that is impacting the left aft strake top surface.
This builds a high pressure reverse flow in the boundary layer and is
filling up the back side of the oil cooler. Since the oil cooler is
porous the pressure bleeds through to the front side
negating (and then some) all of the the normal positive pressure that would
normally be found there. In other words Perry was absolutely
correct when he said the flow was reversed. The intake is fighting
the exhaust.
We are working on a solution. Perhaps putting the intake on the
top and the exit on the bottom of the wing.
BTW This also implies energy is being lost by the interaction of
the leading prop vortex being too close to the trailing edge of the wing.
If I were you pusher guys I would extend the prop further aft as far as
you can get it. Or notch out the trailing edge of the wing just in
front of the prop. Charlie Airseman did exactly that and got very
good results. Here is a picture of Charlie's airplane.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.