Subject: Oil Cooler Test Results
From: ACRE
Date: 6/18/2003, 7:07 PM


Perry Mick wrote:

Paul, didn't you see my oil cooler, it's beautiful! I sent it in to
Pacific Oil Cooler down there in CA a year or two ago, they cleaned it,
straightened the fins, and anodized it. I was hoping it would improve
cooling when I put it in the plane, but there was no difference.

I'd recommend against anodizing any type of radiator.  IIRC, anodizing adds a relatively
thick layer
of aluminum oxide.  Aluminum oxide is a much poorer heat conductor than bare aluminum,
even allowing
for the spontaneous layer of oxide that occurs when bare aluminum is exposed to air.  I
don't think
that this is a significant contributor to the problem in Perry's system, but I could be
wrong.

Russell Kent


After I wrote that I realized my mistake. It is not anodize, it is allodine.
Those guys are oil cooler experts, do a lot of certificated aircraft stuff.
Perry


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.