Perry Mick wrote:
Paul, didn't you see my oil cooler, it's beautiful! I sent it in to
Pacific Oil Cooler down there in CA a year or two ago, they cleaned it,
straightened the fins, and anodized it. I was hoping it would improve
cooling when I put it in the plane, but there was no difference.
I'd recommend against anodizing any type of radiator. IIRC, anodizing adds a relatively
thick layer
of aluminum oxide. Aluminum oxide is a much poorer heat conductor than bare aluminum,
even allowing
for the spontaneous layer of oxide that occurs when bare aluminum is exposed to air. I
don't think
that this is a significant contributor to the problem in Perry's system, but I could be
wrong.
Russell Kent
After I wrote that I realized my mistake. It is not anodize, it is allodine.
Those guys are oil cooler experts, do a lot of certificated aircraft stuff.
Perry
Perry, From my volkswagen engine building days, fog one coat of flat black primer (not engine or
high heat paint) on to your oil cooler. Just enough to cover and no more, otherwise it becomes an
insulator. Best $4 oil temperature remedy around.
Rick Girard
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.