Wayne Peterson wrote:
Still wait'en for the package.
Also, I am useing a gal sump to return fuel from the fuel rail.
Since the fuel will recir and will pick up heat I will place a temp
sensor in the sump to monitor
it's temp.
With the EIS system it is easy to do this job.
Is there any value in putting a chip detector in the redrive?
Is there a need to check the pressure in the redrive?
I have read an email about the latters concern.
Just an idea
Wayne
Going out today Wayne. Sorry about the long delay.
Chip detector would not hurt. Checking the pressure
in the drive will tell you if the plain journal bearings in there are
getting
enough oil. I assume you are using Tracy's redrive? It will also
tell you how much thrust force is on the pressure face if you decide to
go with a built in dyno.
Paul Lamar
Chip detector is in the works and will be retrofitable to all RWS gear
drives. Should be available shortly after I get the EM2 engine monitor into
production.
Tracy Crook
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.