ACRE wrote:

George make sure it is 3.58  inches (90.9 MM) from the 13B end housing

mounting

surface
to the PSRU 13 MM thick mounting surface so Tracy's input shaft will

work.

Paul Lamar

Hi George;

Of course Paul means 3.58 inches NET AFTER machining....Are the

enforcing Ribs

internal or external? Do you have a Final L/O drawing?.....Can't quite

make out

the fiberglass damper flywheel section in the photo, need to see a

better

photograph....Looks pretty good so far ;-)
                                                        Butch

Butch,
Thanks -I tried to get the photo to show the taper of the sides, it's just a
difficult shape to take a photo of.

No drawings I'm afraid !

Not sure where to put the reinforcing ribs, probably a bit of both outside
and a little inside - any suggestions !??
George (down under)

I'll do a 3D of what I think you have in mind and upload it it in the next few hours
George.

Paul Lamar

Is this about what you had in mind George?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.