Mark Steitle wrote:
Paul,
From past statements I have been convinced of the benefits of removing the thermostat and controlling temps with cowl flaps.
What I'm wondering is if I should replace the thermostat with a restrictor plate, or leave it "wide open".
Over the years I have heard & read differing opinions on whether or not a cooling system restrictor (such as a thermostat) is
beneficial or not to cooling of an engine. Lynn Hannover recently stated that he runs a 5/8" restrictor in his 13B race engines
and doesn't have a problem with overheating. This makes some sense as the typical thermostat has a fairly small passage-way for
coolant to pass through.
I got to questioning this again yesterday after reading an article on cooling systems at (don't laugh)
http://www.grapeaperacing.com/GrapeApeRacing/tech/coolingmods.cfm that explains that having a restrictor in the cooling system
actually raises the boiling point of the coolant to close to 300 degrees F by creating 40-45 lbs of pressure between the pump
and the restrictor. If this is true, it seems like this would be highly desirable.
Here's what they say about system pressures, "The pressure in the block is higher than the radiator pressure, this is because
the pump is building pressure due to the thermostat being a restriction. This pressure raises the boiling point of the coolant
and reduces the chance of steam pockets, so never run with out a thermostat (or some form of restriction). The radiator cap will
usually hold 15-18 psi, if the radiator holds the system at 15 psi, the boiling point of plain water will be raised to 250° F.
The water pump can then make an additional 40-45 psi in the engine and bring that boiling point close to 300° F. So as you can
see, pressure is important."
They also state, "Most people seem to think that all a cooling system needs to do is keep the engine from overheating. But what
is not realized is if the engine runs too cool, thermal efficiency is lost and power is reduced."
So, I'm wondering... do I want high pressures, or high flow. It doesn't seem like I can have both at the same time.
Mark S.
You want high pressure and high flow. I kind of doubt those 40 to 45 psi numbers in
the block. For the sake of argument lets assume those numbers are correct. They are easy
to measure however.
Simple solution. Get a higher pressure cap for the rad or put the 20 psi pressure cap
on the other side of the rad on the inlet side of the pump. Let the rad be your restrictor.
It is a restrictor anyway. Why add work for the pump?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.