George Lendich wrote:
Paul and Butch,
I wonder why they call him Butch - because he wants to strangle everyone ? Or is it just me he wants to strangle ?
Anyhow fearing my life is in jeopardy, I've done what I can as quickly as I could, with my limited drawing skills.
I gave deep thought to everyone's suggestions/input and feel the 'elephant ears' as Paul so technically put it, should stay
as it provides for different mounting styles.
I personally would like to mount off the sides and the ears as well, giving two sides to bolt on to and each complementing the
other for strength. It's probably not necessary, but then again I'm no engineer, so I tend to design on the side of caution.
I think it was Ed who said he needed it as narrow as possible - I feel that it is easily cut off for those who need to do that.
The sides remaining are 13mm thick as well.
However I would weld a piece/strip on the inside as a flange (similar to ears but on the inside). That give a 430 mm width about
17" Ed.
For me , I rather have a design who allowed for some removal of material (which anyone can do) rather than having to add
material i.e. welding aluminium.
I like the idea of the stand-offs Butch, this may off-set some of the taper problems i.e get the bolt closer to the housing
wall.
Considering the thickness of it all, what do you think of the placement of the stiffeners I drew in the pictures?
I hope that helps -it's (the drawing) very basic !?
I'm not up to Paul's standard yet!
Still working on some problems. What about the bolts that are in the raised section - just straight through, do you think, with
either solid inserts or tube spacers ??? Probably need solid inserts.
George (down under)
Too HEAVY George. Cut the wall thickness down to 4 or 5 mm where ever possible.
It would be useless for aircraft use unless you do that. Better to buy a new bell housing
from Mazda that is high pressure die cast with walls as thin as 3 mm.
If your foundry can't do thin walls send the pattern to me and I will have my foundry cast them
for you.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.