Subject: Cooling System Restrictor - Good or Bad?
From: ACRE
Date: 6/25/2003, 12:03 AM


From past statements I have been convinced of the benefits of removing
the thermostat and controlling temps with cowl flaps.
What I'm wondering is if I should replace the thermostat with a
restrictor plate, or leave it "wide open".

Over the years I have heard & read differing opinions on whether or
not a cooling system restrictor (such as a thermostat) is
beneficial or not to cooling of an engine.  Lynn Hannover recently
stated that he runs a 5/8" restrictor in his 13B race engines
and doesn't have a problem with overheating.  This makes some sense as
the typical thermostat has a fairly small passage-way for
coolant to pass through.

I got to questioning this again yesterday after reading an article on
cooling systems at (don't laugh)
http://www.grapeaperacing.com/GrapeApeRacing/tech/coolingmods.cfm that
explains that having a restrictor in the cooling system
actually raises the boiling point of the coolant to close to 300
degrees F by creating 40-45 lbs of pressure between the pump
and the restrictor.  If this is true, it seems like this would be
highly desirable.

Here's what they say about system pressures, "The pressure in the
block is higher than the radiator pressure, this is because
the pump is building pressure due to the thermostat being a
restriction. This pressure raises the boiling point of the coolant
and reduces the chance of steam pockets, so never run with out a
thermostat (or some form of restriction). The radiator cap will
usually hold 15-18 psi, if the radiator holds the system at 15 psi,
the boiling point of plain water will be raised to 250° F.
The water pump can then make an additional 40-45 psi in the engine and
bring that boiling point close to 300° F. So as you can
see, pressure is important."

They also state, "Most people seem to think that all a cooling system
needs to do is keep the engine from overheating. But what
is not realized is if the engine runs too cool, thermal efficiency is
lost and power is reduced."

So, I'm wondering... do I want high pressures, or high flow.  It
doesn't seem like I can have both at the same time.

Mark S.


You want high pressure and high flow. I kind of doubt those 40 to 45
psi numbers in
the block. For the sake of argument lets assume those numbers are
correct. They are easy to measure however.

Simple solution. Get a higher pressure cap for the rad or put the 20 psi
pressure cap
on the other side of the rad on the inlet side of the pump. Let the rad
be your restrictor.
It is a restrictor anyway. Why add work for  the pump?

Paul Lamar<<<

alventures wrote:

Not to say they are entirely wrong; but consider that for most
centrifugal water pumps the flow would go to zero before you got to 40
-45 psi; and even if you could, the water would boil at about 270F.  The
vapor pressure of water at 300F is 65.5 psi.

Either leave the thermostat in and take to flow penalty (my dyno
measurements show about 35% reduction), or take it out and  do exactly
as Paul suggests - 20 psi cap on your reservoir tank connected to the
pump inlet side.

The higher flow rate helps the heat rejection side by increasing the
average rejection temperature; lower temp drop across the radiator.  And
since in airplanes we like to keep the rad as small as possible; higher
flow is better.

Al


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.