Subject: George's bell housing.
From: ACRE
Date: 6/25/2003, 1:20 AM


This is roughly what Butch was talking about. External fins. Common
aircraft construction
practice. Thin 4 mm skins and ribs. Minimum 4 mm wall thickness everywhere
except the 13 MM center

The side motor mounts are bolted on out near the extremes of the side box
sections picking up three or more skins. All bolt holes are beefed up
only to a 25 mm dia. and 13 mm thick.

Maybe you need to make two. One for your use and one that people can bolt
Tracy's redrive too. That would be the larger market.

Paul Lamar

Thanks Paul,
Yes I understand what he was getting at and the reduced area would give more
room.

However the thickened faceplate area would have to be on the inside as I
need the complete depth for the starter motor snout, otherwise the
bellhousing will be deeper overall.

Very good point. I agree. The 3D was just a quick and dirty to show what
Butch had in mind.

Another suggestion would be to gradually decrease the stiffeners and perhaps
overlap the stiffeners on the outside with the thickened area on the inside.
Going to have to dress that area anyway for a smooth and parallel (to the
back) PSRU platform.
If people want different starter positions they will have to grind away some
stiffeners. I will design it to accommodate the 3 o'clock position.

I think you should leave the starter in the 4 o'clock position. If you are very clever
and rotate the starter just slightly you can share one of the stock mounting bolts
with the starter bolt. It require a minor amount of grinding on the nose
of the starter to clear the teeth on the ring gear.

When you say you wish the motor mounts, mounted at the extremes - is that
top bottom back and front

A: The brackets would be large enough to cover the total area of the 
flat sides of the bell housing. The bolts would then be near all four
corners of the rectangle. I'll draw something up.

As you know you cant cast 25 mm diameter 13mm thick mounting points on the
sides (only the front and back, as the sides have to be tapered).
This will need to be a strip from the back to the front 13mm thick. 

Correct. Good observation.

If you
want it on the back where I think it's needed most and the front it will
need to be a full panel, If it's needed on the back only it needs to be a
full panel. If it's needed on the top, bottom and front I can cast it in.
Just tell me where you want the mounting points and I will work it out.
How about mounting pads for the starter motor, another reason I settled on
13mm for the full face.
I will end up doing 2 patterns, perhaps even 3, who knows!

George (down under)

See paragraph A: above. I will make a 3d.

I think we are coming to the meeting of the minds here.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.