Georgie!!!!......I'm proud of you,......You're making such great strides

that

I've decided to CANCEL my airline reservation to DownUnder for tomorrow
morning, and give you a "Stay of Execution" in other words no CHOCKIES

for

you :)  .....Instead in the future I will go down there and "Kiss You"

;)

Yeh well - I think I'll pass on that one as well !!

However I do appreciate your advice and If I don't respond immediately, if
may be I have to think on your suggestions it a bit, I do believe we are
locking it down to what is required.

The whole trick in any design is to think LIGHT-LIGHT-LIGHT......I used

to

advice any inexperienced designers to use the following rule to start
with: "When you're absolutely positive that it's strong enough cut down

all

your sizes in half and then crunch the numbers"....It's a good rule to

follow.

In some situations too heavy is just as bad as too light and the average

un

trained Homosapien has a tendency to always over indulge....But don't

worry

there are a lot of talented subscribers keeping an eye on you.

Just take your time, it's a tremendous undertaking on your part but the
learning experience and satisfaction is priceless ;)
I'll personally stay plugged in and continue to bust B---S :)
You're doing a great job!!!!

Thanks,
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.