Subject: Harley / Motorcycle alternator
From: ACRE
Date: 6/26/2003, 10:22 AM


snip...


 Just some thoughts before I tear the Harley apart to put in


a new Alternator and finally install


 the electric starter. What would we do without our


toys..............


 Rick Girard

Rick,
I've been kicking around the idea of using a PM
alternator off a motorcycle or snowmobile for
some time.  I would like to mount the motorcycle
flywheel between the redrive and the 13b
flywheel (and attached to the 13b flywheel) and the
lighting coils to the redrive.  Since I
don't have a MC flywheel lying around I can't get any
measurements.  Do you know the height,
width, weight, and crankshaft hole diameter of the
Harley flywheel?  I'm would like to
determine how much room is needed between the 13b
flywheel and the back of the redrive.  It
sure would be nice to have a 2nd alternator of 10/20
amps on an all-electric airplane!!!!  If
anyone else has any measurements off a MC flywheel
please jump here.

Thanks,
Ken Powell


Ken, I can send you my old parts and you can experiment to
your hearts content. The rotor I am
discarding is original 1977 Harley and is not suited to
adaptation, the spline for the crank was a
machined part spot welded to the rotor face, the new part
has the spline cut into the rotor face
and uses separate spacer washers. The 22 amp upgrade kit
(H-D p/n 29982-81) should work real well.
I'm considering the same thing. The kit price varies by
dealer, I was quoted as high as $225, but
found another dealer who would sell it for $182 and honor a
15% discount coupon I had. The kit
includes rotor, stator, and rectifier.

Rick Girard


Rick,
My thought was to machine out the splines to a 'slipper' fit around Tracy's input shaft.  This would keep the flywheel/rotor centered and also relieve the stress on the rivets or bolts holding the flywheel/rotor to Tracy's flywheel.  Thanks for the offer of borrowing your old parts but I don't think that is neccessary.  How 'thick' is the Harley flywheel (not diameter)?  What we need to calculate is how much longer Tracy's input shaft, redrive spacers and bolts would need to be?
Thanks for the info.

Ken Powell

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.