Subject: Oil flow direction through the cooler
From: ACRE
Date: 6/28/2003, 7:07 AM


Bob Darrah wrote:

OK, I give up!  A while back, some kind sole provided  to the group a
copy
of an RX-7 manual, D index page D-2 that was a super picture of the oil
flow
through the engine.  Even I could almost understand it.

Then comes  D  On-vehicle Maintenance (oil cooler),  page D-14.

The first shows the hot oil going in the side opposite the thermostate,
and
the second shows the hot oil going in adjacent to the thermostate.

Can someone please tell me which way is the correct way for the oil to
flow
through the stock cooler?

Bob Darrah   20b

Bob, follow the diagram on page D-2.  The "oil inlet/outlet" references on
D-14 reference the engine not the oil cooler, i.e. "Oil inlet - to engine" I
ended up initially hooking up my oil cooler reversed due to the same
problem. Oil comes in from the engine to the top of the oil cooler, which
has a direct channel to the oil cooler by past valve..  The valve is
normally open for most of the cold oil to bypass the restriction of the
cooler.  When the oil reaches a temp of approx 150F the valve closes
directing hot oil through the cooler.  Do not remove the valve or you will
continously bypass the cooler.

Ed Anderson

Perry tell them how you blocked the bypass hole. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.