Anyhow Paul, lets see how this goes, I can always start from scratch, if
necessary. It doesn't cost much for me to do a sample and send it over for
you consideration - it's all fun, besides no ones screaming for bellhousing
yet are they ?
George (down under)

********************************************************************************

Good ATTITUDE George, great FORESIGHT!!..........After you're done with the 1st
Bellhousing we'll all see areas of improvement, ways of fine tuning and
checking for proper Fit, us Yanks call it "NitPicking". That's why it's very
important to have a prototype, the big wigs call them POCs (Poof Of Concept).

My only comment at this point:  Hopefully the Four o'clock position of the
Starter will prove satisfactory, we can then shorten the MM mounting Pad to
match the other, this in turn makes the MM Bkts identical and not dissimilar
plus we get rid of a LOT of weight........I'm personally very excited about
this project, for reasons I've posted before :) Thank You George.

  Butch

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.