The starter needs to be spaced out the same as Tracy's redrive so a flat
front surface
Paul,
Ok got you, the drive shaft length - silly me !!
is called for. Put the internal ribs everywhere the flex plate and starter
are not
on about 30 degree increments. Only in the lower half. the upper half will
have the external ribs.
So Paul just clarifying, only the upper half to have external ribs.
These are a job in themselves as they have to be tapered as well.
To save weight I was thinking of reducing the stiffing arch to the minimum
width of say, just wide enough to accommodate a bolt and washer, make it 10
mm thich, radius the edge, and just thicken it up and square off the edges
in theb bolt holes.
A lot of extra work but will start to look like a injection cast.
Butch suggested sharp corners ( stress transfer) for the Mounting Pads, I
can square up these areas if you wish.
Hey Butch are you still with us on this !!
George (down under)
The arch can be 5 mm as well. Just where the bolts go make it thicker.
Paul Lamar
********************************************************************************
Yes indeedy George, I'm right here with you Guys.....Just a little behind on my
reading......Definitely leave the MM Pads Sharp corners other than the standard
casting minimum radius required.......As far as the Psru's 10mm Mounting face I
agree that it should be on the OUTSIDE of the face of the housing....I strongly
suggest that the OD be beveled/chamfered 45 degree and blended to the face of
the Housing.......The re-enforcing Ribs should terminate and blend on this
chamfer 2mm BELLOW the faces surface.........Now for the big kicker, the OD:
Allow yourself a MINIMUM of 3-4mm of extra edge material for casting run-out
during machine turning operation ie: Tracy's ReDrive OD + 8mm.
Paul, if you recall, on my innitial suggestion of the re-enforcing Ribs, I
mentioned a few ribs should be also placed under the Psru Mounting Hub, I still
feel a minimum of 2 should be placed there as this is an area of high
displacement (Loading) during hard landings. this I consider good cheap
Insurance/Assurance.........Guys, this is going to be a BEAUTY!!....I've got a
good nose for these things.......Great job George ;)
Butch
PS
Paul, believe it or not, I just FINALLY got a chance to open up your casting
package.......They are 1st Class Beauties, Excellent job.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.