Subject: Oil flow direction through the cooler
From: ACRE
Date: 6/29/2003, 10:00 PM


Bob Darrah wrote:


OK, I give up!  A while back, some kind sole provided  to the group a


copy


of an RX-7 manual, D index page D-2 that was a super picture of the oil


flow


through the engine.  Even I could almost understand it.

Then comes  D  On-vehicle Maintenance (oil cooler),  page D-14.

The first shows the hot oil going in the side opposite the thermostate,


and


the second shows the hot oil going in adjacent to the thermostate.

Can someone please tell me which way is the correct way for the oil to


flow


through the stock cooler?

Bob Darrah   20b





Bob, follow the diagram on page D-2.  The "oil inlet/outlet" references on
D-14 reference the engine not the oil cooler, i.e. "Oil inlet - to engine" I
ended up initially hooking up my oil cooler reversed due to the same
problem. Oil comes in from the engine to the top of the oil cooler, which
has a direct channel to the oil cooler by past valve..  The valve is
normally open for most of the cold oil to bypass the restriction of the
cooler.  When the oil reaches a temp of approx 150F the valve closes
directing hot oil through the cooler.  Do not remove the valve or you will
continously bypass the cooler.

Ed Anderson


Perry tell them how you blocked the bypass hole.

Paul Lamar

There's nothing to it, but there is no advantage to doing it. Makes no
difference in the abilities of the oil cooler, yet your oil will run too
cool on long descents. With the valve in there, minimum oil temp is held
at 160.

You just remove that big plug in the bottom of the oil cooler, valve and
all. Look inside and you will see the bypass hole. Reach in there with a
1/4" NPT tap on an extension and tap the hole. Of course clean out the
shavings. Put a 1/4" NPT plug in the hole. Remove the thermostat valve
and replace the big plug.

I just got back from Burt Rutan's 60th birthday party in Mojave. 
Rode in the backseat of someone else's Long-EZ. I would much rather be 
in the front seat.

Perry Mick

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.