Subject: Bell housing picture 14
From: ACRE
Date: 6/30/2003, 5:33 AM


The starter needs to be spaced out the same as Tracy's redrive so
a flat
front surface

Paul,
Ok got you, the drive shaft length - silly me !!

is called for. Put the internal ribs everywhere the flex plate and
starter
are not
on about 30 degree increments. Only in the lower half. the upper
half will
have the external ribs.

So Paul just clarifying, only the upper half to have external ribs.
These are a job in themselves as they have to be tapered as well.
To save weight I was thinking of reducing the stiffing arch to the
minimum
width of say, just wide enough to accommodate a bolt and washer,
make it 10
mm thich, radius the edge, and just thicken it up and square off the
edges
in theb bolt holes.
A lot of extra work but will start to look like a injection cast.
Butch suggested sharp corners ( stress transfer) for the Mounting
Pads, I
can square up these areas if you wish.

Hey Butch are you still with us on this !!

George (down under)


The arch can be 5 mm as well. Just where the bolts go make it thicker.

Paul Lamar

Paul,
I knew you were going to say this!!-you like to push my untrained mind hard
Paul - I don't think I can even get a radius on 5mm, but will try.
BTW,  it would be very easy to get the bolt holes slightly off, what I
intend to do is go to an engineering shop and have the pattern drilled
precisely and then build the standoffs around the holes.
So Paul - what is the best drawing you have in CAD that I can give them
please, no doubt they will have some computer driven mill.
George (down under)

I don't have a good cad drawing but it would not be hard to program
this. Just ignor the starter on the bottom.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.