Have you measured the pressure in the block and on the other side
of the restrictor?

Some of you people flying have water pressure gages.
Where are the gages tapped in and what are you seeing in the
way of pressures?

I drilled and tapped a hole in the top front (bell housing end) of the

engine for the pressure gauge. Max reading at 6500 RPM hot engine, low
altitude 16 PSI. The pressure cap on the remote bottle is 10 PSI. No
thermostat. Changes with RPM but not by much. Rads in parallel.

Ian RV6A Australia.

Thanks Ian. Are you coming over with Don?

Paul Lamar

Ian Beadle wrote:

 Too right I am! I will have to fit wing tip tanks and a put a tank where

Irene normally sits.

Ian (Long range) Beadle

OK Don the ball is in your court. Perhaps you can share the tip tank molds
with Ian.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.