Subject: Oil flow direction through the cooler rutan party
From: ACRE
Date: 6/30/2003, 12:08 PM


Vance W Jaqua wrote:


You just remove that big plug in the bottom of the oil cooler, valve
and
all. Look inside and you will see the bypass hole. Reach in there
with a
1/4" NPT tap on an extension and tap the hole. Of course clean out
the
shavings. Put a 1/4" NPT plug in the hole. Remove the thermostat
valve
and replace the big plug.

I just got back from Burt Rutan's 60th birthday party in Mojave.
Rode in the backseat of someone else's Long-EZ. I would much rather
be
in the front seat.

Perry Mick


Perry - It was a shame that your ducted EZ was not there, I am sure it
would
have
opened a lot of favorable comment'
Vance


How did you get that picture Vance? Did somebody let you up on the roof
of the hangar?

Paul Lamar


I have my spies. And I protect my sources. - Vance

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.