Vance W Jaqua wrote:

You just remove that big plug in the bottom of the oil cooler, valve and
all. Look inside and you will see the bypass hole. Reach in there with a
1/4" NPT tap on an extension and tap the hole. Of course clean out the
shavings. Put a 1/4" NPT plug in the hole. Remove the thermostat valve
and replace the big plug.

I just got back from Burt Rutan's 60th birthday party in Mojave.
Rode in the backseat of someone else's Long-EZ. I would much rather be
in the front seat.

Perry Mick

Perry - It was a shame that your ducted EZ was not there, I am sure it would
have
opened a lot of favorable comment'
Vance

How did you get that picture Vance? Did somebody let you up on the roof
of the hangar?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.