How-to-measure.txt Here is how to double check my work. We will do a little reverse engineering. The O-ring grooves are two half circles connected by straight sections to form sort of an oval. Measure across from side to side on the end housing to the inner edge of the O-ring groves This then is the inner diameter of the half circle. We will call this dimension SSL. For the inner O-ring this diameter is 7.5" Outer diameter is is 9.75". These form two circles of 23.562 circumference and 30.63 circumference. C = D X Pi (3.1416) Measure the distance up and down to the inner edge of the O-ring grooves. For the inner O-ring groove this dimension is 9.75 (confusingly). Outer o-ring groove is right on 12 inches. We will call this dimension VL for vertical length. VL-SSL gives us the length of the straight sections. We have two straight sections 9.75- 7.5 or 2.25 inches in length for the inner o-ring slot and 12 - 9.75 or 2.25 for the outer O-ring slot straight sections. There fore the inner circumference is 23.562 + 2.25 + 2.25 or 28.062". Close to the number we got below. Divide by 3.1416 to get the equivalent diameter. For the outer o-ring slot the circumference is 30.63 + 2.25 + 2.25 or 35.13. Also close to the number we got below. Now to be real precise you must repeat these measurements for the outer O-ring slot grooves. Or we could merely take these numbers below as the center line numbers or OD numbers. In any event you want to err on the small side as you are going to cut pieces of plywood the exact size of the inside wall of both slots and slip the o-rings over this plywood form for for a few days so they will take a set. Other wise you will play hell getting the o-rings to lie flat in the grooves when you assemble the engine.