I don't have a good cad drawing but it would not be hard to program
this. Just ignor the starter on the bottom.
Paul Lamar
Paul,
This drawing is in reverse(mirror image) from your other drawings -is that
correct !?
That's Tracy's drawing and I think it is from the psru side looking at
the back of the engine.
Also your solid cad drawings show the starters bottom mounting hole to be
lower than the other side, when the opposite is true (by 8mm) - correct !?
Just checking myself !!
George (down under)
Correct. My mistake. Hopefully you have
an end housing you can use to check these things :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.