Has anybody tried the A-lum-rite brazing?
Al
Al,
Fire extinguisher containers are actually pretty easy to weld using
TIG. That would be my preferred choice. I was planning on using a
fire
extinguisher for a surge tank, but decided against it later on. But I
did
practice on one and it was pretty easy to weld. BTW, the local fire
extinguisher service center gave me an empty.
Mark S.
Yeah; I picked one up at the local extinguisher service place for
nothing. It holds 1 1/2 qts, 3 3/8 diameter, and with the paint off
is nice shiny aluminum. Very light weight, and the configuration is
good for my setup. Haven't done any cutting yet, but guessing .035 -
.040 wall. Thought it might be a challenge to try to weld in bungs for
threaded fittings (and billet neck) because of thick to thin; but then I
have no experience welding aluminum.
Al
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.