Subject: Extinguisher Bottle surge tank
From: ACRE
Date: 7/3/2003, 8:57 AM


Has anybody tried the A-lum-rite brazing?

Al


Al,
Fire extinguisher containers are actually pretty easy to weld using
TIG.  That would be my preferred choice.  I was planning on using a
fire
extinguisher for a surge tank, but decided against it later on.  But I
did
practice on one and it was pretty easy to weld.  BTW, the local fire
extinguisher service center gave me an empty.

Mark S.


Yeah; I picked one up at the local extinguisher service place for
nothing.  It holds 1 1/2  qts,  3 3/8 diameter, and with the paint off
is nice shiny aluminum.  Very light weight, and the configuration is
good for my setup.  Haven't done any cutting yet, but guessing .035 -
.040 wall.  Thought it might be a challenge to try to weld in bungs for
threaded fittings (and billet neck) because of thick to thin; but then I
have no experience welding aluminum.

Al

While I'm not planning on using it for my purge tank, I was thinking that it
might make a good lightweight overflow bottle.

Mark S.

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.