George Lendich wrote:

Paul,
On those engine mounts you drew up for me, give me your  dimensions and

I will do a pattern and have a couple cast-up.

George (down under)

That's fine but you will have to do three different sizes.
A side by side plane uses wider motor mounts. If you can do that
that would be great. I'll work up something in the next few days.

Paul Lamar

Paul,
Not a problem on those different size engine mounts. It's those stiffeners
on the bellhousing causing me a headache but I think I've got them sorted
out.
I will just do the one set initially for a trial, perhaps you could put it
on your engine test stand and give it a good work-out.
George(down under)

Sure be glad too. 
Put some stiffeners on the outside of the bottom. That should be easy to do.

Do you have a machine shop that can do the machining?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.