Bob Darrah wrote:
I am building a test set using my CC mill as a power source. I will be
able to
run the pump up to 7000 RPM and drive it with a 2 HP mill motor.
7000 rpm, 2 HP, well, maybe for a short time.
Bob Darrah
I don't follow you Bob. The mill does not run at 7000 RPM of course.
I have two 8 inch A belt pulleys on the mill spindle and a
3 inch water pump pulley so the mill spindle must run
at about 2600 RPM to get 7000 at the pump. As I recall
I think my top CC mill spindle RPM is 2500 so that should give me
6,650 RPM. Not quite 7000 but up there.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.