Subject: Beading tubing
From: ACRE
Date: 7/9/2003, 9:04 AM

"Schertz, William W." wrote:

Paul,
I think Al Gietzen was asking about beading aluminum tubing.  I found a
fellow builder about 30 miles away that owned a Parker beading tool set, and
took my tubing up to his shop to do the beading (he doesn't let them out of
his sight!).

Aircraft Tool Supply offers two beading tools, PDF attached.

Bill Schertz


Yes I know and that is what my drawing was for. A CHEAP aluminum tubing beading tool.
 

The price at $300 from Aircraft tool  is outrageous when it it so simple to make.

Here is their add anyway for you rich folks. :)

http://www.aircraft-tool.com/

I have never seen a reasonably priced tool from that outfit. I don't even
bother to look at their motor home booth at air shows anymore.


ATS-PARKER TUBE BEADING KIT             Pre-Order now and save $100!
 Even though they are no longer being produced, the Parker is still the finest beading tool ever made. That's why
 we've sold hundreds of them over the years as a refurbished surplus item. Our supply is now exhausted, but these
 tools are in such demand that we've made special arrangement to recreate this classic in every detail. The new
 ATS-Parker Beading Tool will make perfect, mar-free beads in aluminum, copper, brass, and mild steel tubes in sizes
 ranging from 1/4" to 1". It will be available in August 2003, but if you pre-order now, we'll take $100 off the normal list
 price of $399.95. 
 No. AP145
                               Order before 7/31/03
                                                                  $299.95


BTW The pdf you kindly sent from aircraft tool was a bit too big to publish.


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.