Bill;
According to their catalog the largest size in the Parker set is for 1"
tube. I'm doing 1 1/4 and 1 1/2. What dia. Was your tube? How much
did he charge you to do it
Paul's right; very expensive tools to use for a couple of beads. But
then the simple "cheap" tool requires making the mandrels for each size
and finding a hydraulic press.
Seems like the one Bill Adkins made should work. Maybe he was trying to
make too high a bead. Only needs to be about 1/16", maybe a bit more.
I checked 4 local sheet metal shops; nobody could work with tubes less
than a few inches dia. Their bead rollers are for beading flat stock.
Maybe putting on a weld bead and grinding it smooth is the easiest. My
tubing has to be welded in about a dozen or more places anyway.
Thanks to all for the help and ideas; especially Paul!
Al
Along those lines, have you considered finding a tubing size that is a slip fit on the exterior, cutting off a 1/8" section, slipping it over the tube to be "beaded" and having it tack welded inplace?
There was no charge for the use of the beading tools, just had to do it at his shop. I was beading 3/4" tubing.
Bill Schertz
If you make them wide enough (1/8") you can use three small counter sunk flat head rivets
to hold them on.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.